The assessment of Mungbean seed yield and quality changes in response to environmental factors in different planting dates

Document Type : Original Articles

Authors

1 Department of Agronomy, Gorgan University of Agricultural Science and Natural Resources, Gorgan, Iran

2 Department of Agronomy, Gorgan University of Agricultural Science and Natural Resources, Iran

3 Soil & Water Researh Department, Golestan Agricultural & Natural Resources Research & Education Center, AREEO, Gorgan, Iran

Abstract

Introduction
Planting date is one of the important issues in agronomy that could be changing quantitative and qualitative characteristics of crop seeds. Planting date changes seed quality by providing different environmental conditions such as temperature, relative humidity, day length, radiation, and incidence of pathogens. It is also effective on seed yield. It affects duration of growth and development. A suitable planting date leads to optimal utilization of climatic conditions such as temperature, humidity, day length. It is also important for flowering and grain filling period to take place at the same time with favorite environmental conditions. As a result, it can improve seed yield and seed quality. Some factors such as high temperatures, frequent wetting and drying of air, high relative humidity, and continuous rainfalls have a significant negative effects on seed quality. These conditions during seed development reduce seed quality in the field. It is obvious that such conditions can be occurred on both early and late planting dates. Thus, according to an important role of planting date in determination of seed yield and quality, in this study the effects of environmental conditions during seed filling period on seed yield and quality of mungbean (Vigna radiata L.) were evaluated by implementing different planting dates in field conditions.
 
Materials & Methods
This experiment was conducted as a randomized complete block design with three replications at Agricultural Research Station of Gonbad during 2010, which is located at three kilometers northeast of the city, with latitude and longitude of 37˚16́ N and 55˚12́ E, respectively, and a height of 45 meters above sea level. In this study, the genotype VC-1973A was cultivated in five planting dates. The planting dates included April 21, May 10, June 3, June 20 and July 12. The mungbean developmental stages were divided into three stages includes planting to flowering (PD-R1), flowering to beginning of seed filling (R1-R5), and beginning of seed filling to seed maturity (R5-R7). Afterwards, the relationship between the length of these developmental stages and environmental factors (temperature, relative humidity, rainfall and photoperiod) occurring during these stages were evaluated in terms of yield and seed quality. Seed quality was determined via germination, accelerated aging, Electrical conductivity tests, and field emergence percentage. Data analysis was performed by SAS 9.1.3 (Institute, Inc), and Excel 2007 was used to draw figures.
 
Results & Discussion
The results showed that seed quality increased as a result of delayed planting date, whereas seed yield decreased. Germination of the aged seeds increased by 0.23% per day of delay in planting. On the other hand, the electrical conductivity per day of delay in planting decreased by 0.43 µs.cm-1.g-1 which reflects the increase in seed vigor. Delaying the planting date led to an increase in field emergence percentage of about 0.23% per day. In fact, in this study the lowest seed quality was observed for planting date April 21 (first planting date). The reason for this occurrence can be related to occurrence of very high temperatures (more than 40°C) and rainfall during seed development (R5-R7). Although the average air temperature during R5-R7 increased in the next planting dates, but the number of days that temperature was more than 40°C decreased, which consequently led to increased seed quality. Also, the length of R5-R7 decreased by delay in planting date, so filling period (R5-R7) was exposed to environmental factors (particularly high temperatures) for a shorter period. In contrast to seed quality, seed yield decreased linearly with delay in planting date. The highest seed yield (1144.4 kg.ha-1) was achieved in the first planting date (April 21). Then, for each day that planting date was delayed, seed yield decreased by 10.84 kg.ha-1, and finally in the last planting date (July 12) reached the lowest amount (299 kg.ha-1). Reduction of the length of developmental stages (especially R5-R7) was the most important cause of seed yield loss.
 
Conclusion
Although, delay in planting date increased seed quality of mungbean, this delay reduced seed yield. Seed yield in the last planting date decreased 845.4 kg.ha-1 compared to the first planting date. In fact, delay in planting date decreased seed quantity, but increased its quality. The optimum planting date is the date that maintains the seed quality at a satisfactory level and produce high seed yield, simultaneously. Therefore, planting of mungbean in mid-June may lead to higher seed yield, as well as production of high-quality seeds  

Keywords


  1. Anderson, L.R., and Vasilas, B.L. 1985. Effects of planting date on two Soybean cultivars: seasonal dry matter accumulation and seed yield. Crop Science 25(6): 999-1004.
  2. Balduchi, A.J., and McGee, D.C. 1987. Environmental factors influencing infection of Soybean seeds by Phomopsis and Diaporthe species during seed maturation. Plant Disease 71(3): 209-212.
  3. Calvino, P.A., Sadras, V.O., and Andrade F.H. 2003.Quantification of environmental and management effects on the yield of late-sown soybean. Field Crops Research 83(1): 67-77.
  4. Dornbos, D.L., and Mullen, R.E. 1991. Influence of stress during soybean seed fill on seed weight, germination and seedling growth rate. Canadian Journal of Plant Science 35(2): 373-383.
  5. Egli, D.B., Tekrony, D.M., Heitholt, J.J., and Rupe, J. 2005. Air temperature during seed filling and soybean seed germination and vigor. Crop Science 45(4): 1329-1335.
  6. Fehr, W.R., and Caviness, C.E. 1980. Stages of Soybean Development. Iowa Agriculture. Experiment. Stn.
  7. Ghassemi Golezani, K., and Hosseinzadeh Mahootchi, A. 2010. Seed Health Testing Methods. Published by Jihad of Mashhad University Press, 203 p. (In Persian).
  8. Gibson, L.R., and Mullen, R.E. 1996. Soybean seed quality reductions by high day and night temperature. Crop Science 36(6): 1615-1619.
  9. Gorzin, M. 2013. The effects of environmental conditions during pod filling period on soybean (Glycine max (L.) Merr.) seed quality and its relationship with Phomopsis sp. in Golestan province. MSc. Thesis. Gorgan University of Agricultural Science and Natural Resources. (In Persian with English Summary).
  10. Hampton, J.G., and TeKrony, D.M. 1995. Handbook of vigor test methods. The International Seed Testing Association, Zurich. p. 117.
  11. Hashemi Jazi, S.M. 2001. Effects of planting dates on growth and development stages and some agronomic and physiological characteristic in five soybean cultivars. Iranian Journal of Crop Sciences 3(4): 49-59. (In Persian with English Summary).
  12. Kantolic, A.G., and Slafer, G.A. 2005. Reproductive development and yield components in indeterminate Soybean as affected by post-flowering photoperiod. Field Crop Research 93 (2): 212-222.
  13. Keigley, P.J., and Mullen, R.E. 1986. Changes in soybean seed quality from high temperature during seed fill and maturation. Crop Science 26(6): 1212-1216.
  14. Keiser, J.R., and Mullen, R.E. 1993. Calcium relative humidity effects on soybean seed nutrition and seed quality. Crop Science 33(6): 1345-1349.
  15. Koocheki, A., and BanayanAval, M. 2007. Pulse Crops. Publication of Mashhad University. (In Persian).
  16. Mayers, D.J., Laen, R.J., and Byth, D.E. 1998. Adaptation of Soybean (Glycine max) to the dry season of teopices. II. effect of genotype and environment on biomass and seed yield. Australian Journal of Agricultural Research 42(4): 517-530.
  17. Mayhew, W.L., and Caviness, C.E. 1994. Seed quality and yield of short-season soybean genotypes. Agronomy Journal 86(1): 16-19.
  18. Mengistu, A., Castlebury, L., Smith, R., Ray, J., and Bellaloui, N. 2009. Seasonal progress of Phomopsis longicolla infection on soybean plant parts and its relationship to seed quality. Plant Disease 93(10): 1009-1018.
  19. Samarah, N.H., and Abu-Yahya, A. 2008. Effect of maturity stages of winter and spring sowen chickpea (Cicer arietinum) on germination and vigor of the harvested seeds. Seed Science and Technology 36(1): 177-190.
  20. Sastawa, B.M., Lawan, M., and Maina, Y.T. 2004. Management of insect pests of soybean: effects of sowing date and intercropping on damage and grain yield in the Nigerian Sudan savanna. Crop Protection 23(2): 155-161.
  21. Soltani, A., and Maddah, V. 2010. Simple Applications for Teaching and Research in Agronomy. Ecological Society of Shahid Beheshti University Press. 80 p. (In Persian)
  22. Spears, J.F., TeKrony, D.M., and Egli, D.B. 1997. Temperature during seed filling and soybean seed germination and vigor. Seed Science and Technology 25(2): 233-244.
  23. Woodstock, L.W., Furman, K., and Leffler, H.R. 1985. Relationship between weathering, deterioration and mineral leaching from cotton seeds. Crop Science 25(3): 459-466.
  24. Zanakis, G.N., Ellis, R.H., and Summerfield, R.J. 1994. A comparison of changes in vigour among three genotypes of soybean (Glycine max) during seed development and maturation in three temperature regimes. Experimental Agriculture 30(1): 157-170.
CAPTCHA Image