Effect of priming and temperature on emergence and establishment of two lentil (Lens culinaris Medik.) genotypes featuring low and high seed vigor

Document Type : Original Article

Authors

1 Faculty of Agriculture, Tarbiat Modares University, Tehran, Iran

2 Department of Agrotechnology, Faculty of Agriculture, Ferdowsi University of Mashhad, Mashhad, Iran

3 Department of Legumes, Research Center for Plant Sciences, Ferdowsi University of Mashhad, Mashhad, Iran.

Abstract

Introduction
Beans, due to their significant nutritional and crop characteristics, have a high rank in agricultural systems of the world. These plants, by fixing air nitrogen, can increase the amount of nitrogen in the soil. Beans have a long history of cultivation in Iran, and some believe that some of them, such as lentil (Lense culinaris Medik) and chickpea (Cicer arietinum L.), have been domesticated in this country. The lentils are cold and long day and can be cultivated from 0 to 3500 m above sea level, the temperature suitable for growing lentils is 15-25 °C. Spring cultivation of lentils although common in Iran, winter cultivation of lentils has advantages over spring cultivation if successful. Previous research showed that the average plant height of lentils in autumn and winter was 43% higher than spring planting and the highest yield of lentils (1486 kg.ha-1) was obtained from autumn planting. Autumn cultivation is usually accompanied by a low temperature challenge. Low temperatures often affect the growth and productivity of crops, causing significant crop losses. Delay in emergence and decrease in germination percentage of seeds occur due to autumn cold, so priming can be used for seed germination. The purpose of this study was the effects of different priming treatments on reducing cold stress effects on emergence and growth of two lentil genotypes.
 
Material and Methods
The experiment was conducted as a factorial based on completely randomized design with four replications under controlled conditions in 2017 at Ferdowsi University of Mashhad. Factors consisted of lentil genotypes (Robat and Calposh), priming (6 levels of control, Gibberellic acid )C19H22O6(, Potassium nitrate (KNO3), Zinc sulphate (ZnSO4), seed priming Dayan and hydropriming) and temperature (5, 10 and 15ºC). To test and apply treatments, 40 seeds were randomly selected for each treatment. After the end of the priming period (16 h), the seeds were removed from the solution and then placed in the laboratory for 24 h until complete drying. The prepared seeds were 10 seeds in pots of 11 cm diameter light soil and transferred to the growth chamber. Then the studied properties were measured. Data were analyzed using SAS 9.4 software and the means were compared with LSD at 5% probability level.
 
Results and Discussion
The highest emergence percentage (72.5%) was found in Robat in control and 5ºC. Seed vigor in Robat genotype at 15 °C was higher than Calposh genotype, and in both genotypes (with the exception of Calposh genotype the priming primer with zinc sulphate and hydro-priming), the seed vigor increased with temperature. The highest seed vigor (4.91) was found in Robat in 15ºC and priming by seed priming Dayan. The highest plant height was observed in priming by gibberellic acid and 15ºC. In both genotypes, leaf number per plant was increased as temperature increased and was decreased when treated by ZnSO4 and Hydropriming in Calposh. The highest leaf number per plant (4 leaves) was found in Robat in 15ºC and priming by seed priming Dayan. The highest root length (4.04 cm) was observed in seed priming Dayan and 15ºC. The interaction of temperature and priming on root length showed that at 5 °C all priming treatments (with the exception of sulfate priming) compared to the control, at 10 °C priming with Dayan seed solution, potassium nitrate and 15 °C hydropriming. Dayan seed solution and potassium nitrate had more root length than control. Seedlings Robat appear to have higher seed vigor and can compensate for the time elapsed before priming, but seedlings Calposh that are less potent, priming treatments have been able to improve seed vigor.
 
Conclusion
The results of this study showed that the Robat genotype in terms of seed vigor and other emergence characteristics was better than Calposh genotype. As the Robat genotype has higher vigor, so different priming treatments could not have a positive effect. Priming with gibberellic acid and potassium nitrate had the greatest effect in reducing the effects of low temperature (5 °C) on the emergence characteristics of lentil seed. In general, priming with gibberellic acid seeds for autumn or early spring cultivation can be recommended.

Keywords

Main Subjects


  1. AbuTaliban, M.A., and Mohagheghi, A. 2015. Effect of different seed priming treatments on yield and yield components of lentil under drought stress conditions. Journal of Crop Production and Processing 5(15): 129-140. (In Persian).
  2. Azarnia, M., Biabani, A., Esvand, H.R., and Poor Alamdari, G. 2016. Study on the effect of mycorrhizal inoculation and seed priming on root and aerial part characteristics of lentil. Journal of Plant Production Research 22(3): 27-53. (In Persian).
  3. Azarnia, M., and Esvand, H.M. 2013. Effect of hydroperiming and hormonal priming on yield and yield components of chickpea in dry and wet conditions. Journal of Crop Production 6(4): 1-18. (In Persian with English Summary).
  4. Davey, M.W., Stals, E., Panis, B., Keulemans, J., and Swennen, R.I. 2005. High throughput of malondialdehyde in plant. Analytical Biochemistry 347: 201-207.
  5. Emam, Y., and Nicknegad, V. 2011. Introduction to physiology of crop yield. Shiraz University Publication Center. 594 p. (In Persian).
  6. Eskandari, H., and Alizadeh-amraie, A. 2014. Improvement of lentil germination performance under salt and drought conditions using seed priming treatments. Seed Science and Technology 1(42): 87-91.
  7. Esvand, H.R., Tavakol Afshari, R., Sharifzadeh, F., Modarat Arefi, H., and Hesamzadeh Hejazi, M. 2008. Improvement of physiological quality of Agropyron elongatum host by means of hormonal priming for controlling drought conditions. Journal of Agricultural Sciences of Iran 1(39): 53-65. (In Persian).
  8. Ghassemi-Golezani, , Aliloo, A.A., Valizadeh, M., and Moghaddam, M. 2008. Effects of different priming techniques on seed invigoration and seedling establishment of lentil (Lens culinaris Medik). Journal of Food, Agriculture and Environment 6(2): 222-226.
  9. Ghassemi-Golezani, K., and Dalil, B. 2011. Germination and Seed Power T Mashhad University Press. 104 p. (In Persian).
  10. Ghazian Tafreshy, G., Arouei, H., Azizi, M., Khazaee, H., and Vesal, S.R. 2016. Effect of spermidine on induction of cold tolerance in cucumber seedlings of Superdamineum cultivar. Journal of Horticulture 30(3): 547-554. (In Persian).
  11. Jamali, M., Ghaderi-Far, F., Sadeghipour, H.R., Soltani, E., and Alimagham, S.M. 2017. Evaluation of germination of wheat seeds with different levels of seed vigor by using the hydrotime model. Environmental Stresses in Crop Sciences 10(3): 403-413. (In Persian).
  12. Johansen, , Baldev, B., Brouwer, J.B. Erskine, W., Jermyn, W.A., Li-juan, L., Malik, B.A., Ahad Miah, A., and Slim, S.N. 1994. Biotic and abiotic stresses constraining productivity of cool season food legumes In: F.J. Muehlbauer and W.J. Kaiser (Eds.). Expanding the Production and Use of Cool Season Food Legumes. Kluwer Academic Pub. Printed the Netherlands. 175-194.
  13. Kamkar, B., Ahmadi, M, Mahdavi-Damghani, A., and Villalobos, F.J. 2012. Quantification of the cardinal temperatures and thermal time requirement of opium poppy (Papaver somniferum) seeds to germinate using non-linear regression models. Industrial Crop and Products 35: 192-198.
  14. Kujawski, M., Cichosz, G., Podhajna, E., and Sanko, B. 2003. Effect of temperature on proteolysis and organoleptic properties of Edam-type cheese. Food Science and Technology 6: 207-219.
  15. Majda, C., Khalid, D., Aziz, A., Rachid, B., Badr, A.S., Lotfi, A., and Mohamed, B. 2019. Nutri-priming as an efficient means to improve the agronomic performance of molybdenum in common bean (Phaseolus vulgaris). Science of Total Environment 661: 654-663.
  16. Mansoori, B., and Abutalebian, M.A. 2013. Effect of on-farm seed priming and supplementary irrigation on emergence rate, yield and yield components of two chickpea (Cicer arietinum) cultivars. Journal of Plant Production Research 20(2): 179-196. (In Persian with English Summary).
  17. Mehdi Nejad Moghadam, N., Saffalian., O., Zare, N., Sedghi, M., and Karimizadeh, R.A. 2018. The effect of salinity stress on some morphological traits of different lentil cultivars. Second National Conference on Salt Stress in Plants and Strategies for Agricultural Development in Salt: 14 and 15 September. Shahid Madani University of Azerbaijan. 6-10. (In Persian).
  18. Moradi, R., Alizadeh, Y., Nezami, A., and Eshghizadeh, H.R. 2013. Study of lentil (Lens culinaris) seed size on germination and seedling properties in drought stress condition. Iranian Journal of Field Crops Research 11(3): 377-389. (In Persian with English Summary).
  19. Mousavi, C.K., and Ahmadi, A.R. 2009. The effect of planting date and weeds on the performance of three lentil cultivars (Lens culinaris) in Khorramabad dryland conditions. Agricultural Research: Water, Soil and Plant in Agriculture 8(1): 13-26. (In Persian).
  20. Naguib, D.M. 2019. Metabolic profiling during germination of hydro primed cotton seeds. Biocatalysis and Agricultural Biotechnology 17: 422-426.
  21. Nezami, A., Khazaei, H., Shojaeinoferest, K., and Rezaei, J. 2011. Evaluationof freezing tolerance of lentil (Lens culinaris ) genotypes under controlled conditions. Crop Production in Environmental Stress 3(1 and 2): 45-58. (In Persian).
  22. Qayyum, M.M.N., Butt, M.S., Anjum, F.M., and Nawaz, H. 2012. Composition analysis of some selected legumes for protein isolates recovery. The Journal of Animal and Plant Sciences 22(4): 1156-1162.
  23. Ramezani, M., and Rezaei Sokht-Abandani, R. 2013. Effects of osmopriming on lentil seed germination components in arid areas. Technical Journal of Engineering and Applied Sciences3(17): 2002-2006.
  24. Sakar, D., Durutan, N., and Meyveci, K. 1988. Factors which limit the productivity of cool season food legumes in Turkey. p 37-146. In: R.J. Summerfield (Ed.). World Crops: Cool Season Food Legumes. Kluwer, the Netherlands.
  25. Sanghera, G., Wani, S.H., Hussain, W., and Singh, N. 2011. Engineering cold stress tolerance in crop plants. Current Genomics 12: 30-43.
  26. Saxena, M.C. 1993. The challenge of developing biotic and abiotic stress resistance in cool season food legumes. In: K.B. Singh and M.C. Saxena (Eds.). Breeding for Stress Tolerance in Cool-Season Legumes. John Wiley and Sons, New York, p. 3-14.
  27. Sharifi, H., Sadeghian, S.Y., and Hosseinpor, M. 2000. Autumn- Sown Sugar Beet Production: Present and F Sugar Beet Seed Institute. (In Persian).
  28. Singh, K.B., and Saxena, M.C. 1993. Breeding for Stress Tolerance in Cool-Season Food L Chichester, UK: Wiley, 635: 52-65.
  29. Torabi, B., and Soltani, A. 2013. Quantifying response of chickpea emergence to air temperature. Journal of Crop Production and Processing 2(6): 109-120. (In Persian).
  30. Toselli, M.E., and Casenave, E.C. 2002. The hydrotime model analysis of cottonseed germination as tool in priming. Seed Science and Technology 30(3): 549-557.
  31. Yaran Pour, M., and Porfalahi, F. 2017. Seed priming effect on germination parameters of alfalfa seed under cold stress conditions. Seventh National Conference on New Ideas in Agriculture. (In Persian).
  32. Yusefi Tanha, E., Fallah, S., and Taddayon, A. 2015. Effect of seed priming on some effective physiological parameters on seed germination of pea (Pisum sativum) under chilling stress. Journal of Plant Process and Function 4(13): 1-15. (In Persian).
  33. Zyai, S.M., Nezam, A., Valizadeh, J., and Jafari. M. 2012. Evaluation of possible autumn planting of lentil in Saravan condition. Agronomy Journal (Pajouhesh & Sazandegi) 104: 55-62. (In Persian with English Summary).
CAPTCHA Image
  • Receive Date: 22 October 2019
  • Revise Date: 16 May 2020
  • Accept Date: 04 November 2020
  • First Publish Date: 30 November 2020